Siemens SINAMICS G120C User Manual

SINAMICS
SINAMICS G120C
SINAMICS G120C Converters
Operating Instructions
Edition 02/2023, Firmware 4.7 SP14
02/2023, FW V4.7 SP14
A5E34263257B AK
Changes in the current
edition
Fundamental safety
instructions
1
Introduction
2
Description
3
Installing
4
Commissioning
5
Uploading the converter
settings
6
Protecting the converter
settings
7
Advanced commissioning
8
Alarms, faults and system
messages
9
Corrective maintenance
10
Technical data
11
Appendix
A

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating