Siemens SINAMICS G120C User Manual

5. Wait until the converter has transferred the settings from the memory card.
2.
6. Back up the settings so that they are protected against power failure.
2.2.
2.
2.
7. Start to commission the safety functions.
2.2.2.
8. Enter the password for the safety functions.
2.2.
9. Con󹪝rm the setting of the safety functions.
2.2.
10.Exit commissioning of the safety functions.
2.2.
11.Back up the settings so that they are protected against power failure.
2.2.
2.
2.
12.Switch o󹪜 the converter power supply.
13.Wait until all LEDs on the converter are dark.
14.Switch on the converter power supply again.
15.Perform a reduced acceptance test.
Reduced acceptance after component replacement and 󹪝rmware change (Page417)
You have transferred the settings from the memory card to the converter.
❒
Corrective maintenance
10.2Downloading the converter settings
SINAMICS G120C Converters
392 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating