Gearbox
9.3 Motors with helical and bevel gearboxes
Synchronous Motors 1FK7
210 Configuration Manual, (PFK7S), Edition 12.2006, 6SN1197-0AD16-0BP1
Worm geared motor
Nominal ratio
I
norm 0 =
9,2 to 70
Output torque
M
2 =
80 Nm to 430 Nm
Max. perm. accelerating torque
M
2max =
96 Nm to 720 Nm
Mechanical options Solid shaft, hollow shaft with key, hollow shaft with
tensioning element/shrink disk, flange, mounting feet,
tapped hole group, torque bracket
Configuring geared servo motors with the CAD CREATOR
The "CAD CREATOR" tool can be used to configure the geared servomotors and as a guide
to selection and ordering. This tool contains the relevant data and all dimension sheets.
The CAD CREATOR is available on CD-ROM (order number 6SL3075-0AA00-0AG0) and
as an Internet application.
You will find additional information on the Internet at:
http://www.siemens.com/cad-creator
To Next Page
Loading...
