Siemens SINAMICS S120 - Power Connection; DRIVE-Cliq

Application
2.2 Electrical connections
Synchronous Motors 1FK7
Configuration Manual, (PFK7S), Edition 12.2006, 6SN1197-0AD16-0BP1
33
2.2.2 Power connection
Warning
The motors are not designed to be connected directly to the line supply.
Connection assignment, power connector at the motor





8
9
:
*1<(
%'
B
%'

3RZHUFRQQHFWLRQ89:
8
9
:
*1<(
%'

%'
B
&RQQHFWRUVL]H
&RQQHFWRUVL]H
%UDNHFRQQHFWLRQ%'%'ದRQO\ZKHQRUGHUHG





8
9
:
*1<(
&RQQHFWRUVL]H

%'
B
%'

Figure 2-5 Power connection
2.2.3 DRIVE-CLiQ
DRIVE-CLiQ is the preferred method for connecting the encoder systems to SINAMICS.
Motors with a DRIVE-CLiQ interface can be ordered for this purpose. Motors with
a DRIVE-CLiQ interface can be directly connected to the associated motor module via the
available MOTION-CONNECT DRIVE-CLiQ cables. The MOTION-CONNECT DRIVE-CLiQ
cable is connected to the motor in degree of protection IP67. The DRIVE-CLiQ interface
supplies power to the motor encoder via the integrated 24 VDC supply and transfers
the motor encoder and temperature signals and the electronic type plate data, e.g. a unique
identification number, rating data (voltage, current, torque) to the control unit.
The MOTION-CONNECT DRIVE-CLiQ cable is used universally for connecting the various
encoder types. These motors simplify commissioning and diagnostics, as the motor and
encoder type are identified automatically.