Drive with control via PROFINET
8.8 Configuring a telegram
Getting Started - SINAMICS Startdrive
58 Getting Started, 01/2015
Configuring a telegram
Telegram configuration
A telegram must be configured for the cyclic communication between the drive and the
controller. You have already selected a telegram in the wizard during the commissioning of
the drive. Telegram 1 was used in the example. You can configure and also change the
telegram subsequently.
Proceed as follows:
1. In the parameter view of the drive, you can display and configure the address ranges of
the telegram in the "Communications" screen form. This is separated according to receive
and send direction. It is recommended that you use the default settings.
To Next Page
Loading...
