Siemens SINAMICS Startdrive - Acceptance of the Safety Functions

Safety Integrated
9.6 Acceptance of the safety functions
Getting Started - SINAMICS Startdrive
Getting Started, 01/2015
87
9.6
Acceptance of the safety functions
Acceptance test
The acceptance test of the drive device is part of the acceptance test of the complete
machine or system. The acceptance test checks whether the drive-integrated safety
functions are set to match the configured safety function of the machine. The results of the
acceptance test and the settings of the drive-integrated safety functions must be
documented.
The safety commissioning and programming are completed after performing and
documenting the acceptance.
Note
A detailed description of the acceptance test and the documentation scope is contained in
the
SINAMICS G120 Safety Integrated Function Manual.
Because the
acceptance documentation is not generated automatically in the Startdrive, use
the tabular overview of the acceptance logs contained in the Function Manual appendix.