Siemens SINAMICS - Page 99

Error
value
Significance Remark Additional
info
0x6F Parameter %s [%s]: Write access only
in the commissioning state, power unit
(p0010 = 2).
– –
0x70 Parameter %s [%s]: Write access only
in the quick commissioning mode
(p0010 = 1).
– –
0x71 Parameter %s [%s]: Write access only
in the ready mode (p0010 = 0).
– –
0x72 Parameter %s [%s]: Write access only
in the commissioning state, parameter
reset (p0010 = 30).
– –
0x73 Parameter %s [%s]: Write access only
in the commissioning state, Safety
(p0010 = 95).
– –
0x74 Parameter %s [%s]: Write access only
in the commissioning state, tech. ap‐
plication/units (p0010 = 5).
– –
0x75 Parameter %s [%s]: Write access only
in the commissioning state (p0010 not
equal to 0).
– –
0x76 Parameter %s [%s]: Write access only
in the commissioning state, download
(p0010 = 29).
– –
0x77 Parameter %s [%s] must not be writ‐
ten during download.
– –
0x78 Parameter %s [%s]: Write access only
in the commissioning state, drive con‐
figuration (device: p0009 = 3).
– –
0x79 Parameter %s [%s]: Write access only
in the commissioning state, define
drive type (device: p0009 = 2).
– –
0x7A Parameter %s [%s]: Write access only
in the commissioning state, data re‐
cord base configuration (de‐
vice: p0009 = 4).
– –
0x7B Parameter %s [%s]: Write access only
in the commissioning state, device
configuration (device: p0009 = 1).
– –
0x7C Parameter %s [%s]: Write access only
in the commissioning state, device
download (device: p0009 = 29).
– –
0x7D Parameter %s [%s]: Write access only
in the commissioning state, device pa‐
rameter reset (device: p0009 = 30).
– –
0x7E Parameter %s [%s]: Write access only
in the commissioning state, device
ready (device: p0009 = 0).
– –
Communication
A.1 Communication
Industrial Security
Configuration Manual, 08/2017, A5E36912609A 99