SINUMERIK 801 5-1
Start-Up
Setting Up 4
4.1 Setting Up NC Parameters
System configuration
The system configuration for SINUMERIK 801 is a turning variant, i.e.: X axis
is set as the 1
st
axis, Z axis the 2
nd
and spindle the 3
rd
. Technology settings
are also for turning machining.
Notice
NC parameters can not be changed unless the Machine Manufacturer
password (“Evening”) has been input.
Parameterization Parameter settings for SINUMERIK 801 are given in following tables. In which,
IPR refers to pulses per motor revolution, RPM revolutions per minute and I
the number of pulses.
SINUMERIK 801：
MD Designation Unit Axis
Input
value
Description
30130 CTRLOUT_T
YPE
- X，Z 2
Output type of
setpoint (setpoint
branch): the setpoint
signals are output to
connector X4
30240 ENC_TYPE - X，Z 3
Type of actual value
acquisition (actual
position value)
(encoder no.):
3: Encoder for
stepper motor
34200 ENC_REF_M
ODE
- X，Z 2* or
4
*
Type of position
measuring system:
2: BERO
4: Bero with two
edges
34210 ENC_REF_
STATE
- X，Z
0 or
1
Reference state
0: Function “Record
reference point”
inactive
1: Function “Record
reference point”
activated
To Next Page
Loading...
