Siemens SINUMERIK 802C - Page 11

SINUMERIK 802C Control System
1.1 Components of the SINUMERIK 802C
1-11
SINUMERIK 802C
6FC5 597–3AA20–0BP2 (01.02)
S Toolbox
– WinPCIN transfer program for a PC/PG (programming device) to transfer user data and
programs
– Text manager
– Cycle kit for loading into the control system using WinPCIN
– User program library
– Technological machine data files
– Programming tool
S Update diskettes
– Update program with operator prompting system
– 802C system software, packed, for loading and programming the
SINUMERIK 802C via an update program.
User data
User data are:
S Machine data
S Setting data
S Tool data
S R parameters
S Zero offsets
S Compensation data
S Part programs
S Standard cycles
Data saving
Modified user data are saved for at least 50 h after power off or power failure. After then, they
might get lost.
!
Warning
To avoid data loss, the operator must carry out data saving (see Section 4.1.4).