Start-Up
4.7 Commissioning
4-87
SINUMERIK 802C
6FC5 597–3AA20–0BP2 (01.02)
Interface signals
“Traversing minus” 39030004 bit 6
“Traversing plus” 39030004 bit 7
Reciprocation mode for gear change
The reciprocation mode of the spindle is intended to facilitate the gear change. For reciproca-
tion mode, the following axis MD and interface signals are relevant:
Number Description
Machine data
35400 Reciprocation speed
35410 Acceleration when reciprocating
35430 Start direction in reciprocation
35440 Reciprocation time for M3 direction
35450 Reciprocation time for M4 direction
Interface signals
“Change gear” 39032000 bit 3
“Reciprocation speed” 38032002 bit 5
“Reciprocating by PLC” 38032002 bit 4
“Set direction of rotation CCW” 38032002 bit 7
4.7.4 Completing the Start–Up
After start–up of the control system by the machine manufacturer, the following should be ob-
served prior to delivery to the final customer:
1. Change the default password for access level 2 from ”EVENING” to your own password.
If the machine manufacturer uses the password ”EVENING” for access level 2 during the
start–up work, the password must be changed.
– Press the softkey Change passw.
– Enter the new password and press OK to confirm.
– Note the password in the Manufacturer Documentation.
To Next Page
Loading...
Need help?
General
