Siemens SINUMERIK 802C - Page 137

Index
Index-137
SINUMERIK 802C
6FC5 597–3AA20–0BP2 (01.02)
Index
A
Access levels, 4-42
B
Boot messages, 4-48
C
Configuration of the RS232 interface connection
(X8), 2-27
Connecting handwheels (X10), 2-29
Connecting NCREADY (X20), 2-30
Connecting the digital inputs and outputs (X2003
... X2006), 2-31
Connecting the Feed Drives (X2), 2-23
Connecting the individual components, 2-21
Connecting the Operator Panel, 2-21
Connecting the spindle drive (X3), 2-26
Connection diagram, 2-20
E
ENC and operator panel power supply (X1), 2-35
Encoder matching to spindles, 4-77
G
Grounding, 2-36
Grounding diagram, 2-36
I
Installing and Dismantling the SINUMERIK 802C,
2-15
Interfaces and cables, 2-18
L
LEDs and operating elements on the ENC unit,
2-38
M
Machine and Setting Data, Unit, 4-43
Manual machine, 7-125
Default assignment, 7-133
I/O assignment, 7-130
Installation, 7-125
Machine data, 7-129
Switching the language, 7-128
Switching the user interface, 7-128
P
Protection levels, 4-42
S
Spindel data, Spindle modes, 4-85
U
Updating the System Software, 5-91