Detailed Description
2.12 Block descriptions
PLC Basic Program Solution Line (P3 sl)
2-120 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Location_number_to = -1, Magazine_number_to = Magazine_number:
An empty location for the tool specified with a T number is searched for in the specified
magazine. Location_number_ID and magazine_number_ID can be set as search criteria or
not (= -1). The PI is acknowledged positively or negatively depending on the search result.
Location_number_to = Location_number, Magazine_number_to = Magazine_number:
The specified location is checked, to confirm that it is free to be loaded with the specified
tool. Location_number_ID and magazine_number_ID can be set as search criteria or not
(= -1). The PI is acknowledged positively or negatively depending on the search result.
Command parameters 1 and 2 are located at source.
Loading: If source is an internal loading magazine, then the command parameters are located at
the target (a real magazine).
Unloading: Source is always a real magazine.
Note
Before and after this PI service, the MMCSEM PI service must be called up with the
associated parameter WVar1 for this PI service. See PI service MMCSEM for more
information.
Parameter assignment
Signal Type Value range Meaning
PIService ANY PI.TMFDPL Empty location
for loading
Unit INT 1, 2 TOA
WVar1 INT T number
WVar2 INT Location_number
_to
WVar3 INT Magazine_number
_to
WVar4 INT Location_number_ID
WVar5 INT Magazine_number
_ID
PI service: TMFPBP
Empty location search
Function:
(dependent on parameter assignment)
See description in FB 7.
To Next Page
Loading...
Need help?
General
