Transformations
7.11 Deselect transformation (TRAFOOF)
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
7-77
7.11 7.11 Deselect transformation (TRAFOOF)
Function
The TRAFOOF command disables all the active transformations and frames.
Note
Frames required after this must be activated by renewed programming.
Please note:
The same restrictions as for selection are applicable to deselecting the transformation (see
section "Constraints when selecting a transformation").
Programming
TRAFOOF
Parameters
TRAFOOF Disables all the active transformations/frames
To Next Page
Loading...
