User stock removal programs
14.2 Contour preparation (CONTPRON)
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
14-5
Explanation of column contents
(0) Pointer to next contour element (to the row number of that column)
(1) Pointer to previous contour element
(2) Coding of contour mode for the movement
Possible values for X = abc
a = 10
2
G90 = 0 G91 = 1
b = 10
1
G70 = 0 G71 = 1
c = 10
0
G0 = 0 G1 = 1 G2 = 2 G3 = 3
(3), (4) Starting point of contour elements
(3) = abscissa, (4) = ordinate of the current plane
(5), (6) Starting point of the contour elements
(5) = abscissa, (6) = ordinate of the current plane
(7) Max/min indicator: Identifies local maximum and minimum values on the contour
(8) Maximum value between contour element and abscissa (for longitudinal
machining) or ordinate (for face cutting). The angle depends on the type of
machining programmed.
(9), (10) Center point coordinates of contour element, if it is a circle block.
(9) = abscissa, (10) = ordinate
To Next Page
Loading...
Need help?
General
