3 Operating Sequences 11.90
3.1.14 “SIMULATION”
Example of the simulation of a part program ( ” %16 ” ) :
% 16
N05 G1 Z50 F100 LF
N10 X20 Y10 D3 LF
N15 Z10 LF
N20 L1 P5 LF
N25 M30 LF
Subroutine L1
N05 G1 G91 Y50 F500 LF
N10 X10 LF
N15 Y-50 LF
N20 X10 LF
N25 M17 LF
((Bild 810M/ 39 einmontieren))
Now you can enter/modify up to three correction numbers D ... and the respective values
for cutter length (l
3
) using the keys. After each input and pressing the input key the cursor
jumps to the next input field.
SIMULA-
TION
... this input screen form appears for
”Simulation data”.
The current input field in which you
can enter/modify values is marked in
inverse video.
((Bild 810M/ 38 einmontieren))
SIMUL.-
DATA
If, after you have chosen the type of display, you
press the ”SIMULATION” and ”SIMULATION
DATA” softkeys ...
The following display appears:
%16 Part program no.
N . . Block number
L . . Subroutine no.
P . . Subroutine passes
X . ., Y. ., Current axis values
Z . .,
X124.60 Simulation area for ”X”
Y70.000 Simulation area for ”Y”
F . . Current feedrate
T-, D-, H-, M-, S- functions are not
displayed. Any subroutine nesting is
simulated, but not displayed!
d) ”SIMULATION DATA”
3-78 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)
To Next Page
Loading...
