Siemens SINUMERIK 810M - Page 308

09.91 8 Appendix
8.2 Lists of terms used
Term Section
PLANE 2.5
PLAYBACK 2.5
Playback 3.2.6
PLC ALARM 2.5
PLC/MD 2.5
PLC MESSAGE 2.5
PLC STATUS 2.5
”Position not yet reached” display 2.1.1.2
PROGRAM CONTROL 2.5
PROGRAM CONTROL 3.2.3.1
Program edit 3.1.12
PROGRAM END 2.5
PROG. HANDL. 2.5
Program input 3.1.10
Program interruption 3.2.3.4
Program management 3.1.13
Program memory 3.1.13.8
”Program running” display 2.1.1.2
Program sequencing (OPS) 3.2.3.5
PRG. STP. ON-OFF 2.5
Program stop/Program start 2.1.1.6/2.1.2.1
RS232 (V.24) interface 6.1
Rapid 2.1.1.6
Reference point approach 2.3.2/3.1.2
RENAME 2.5
REORG 2.5
Repositioning 2.3.2
Repositioning (Repos) 3.2.12
RESET 2.5
Reset 2.1.1.6/2.1.2.1
Reset with change of mode 2.3.4
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02 8-7
SINUMERIK 810M, GA3 (BN)