Siemens SINUMERIK 840D sl OP 010 - Component Replacement Procedures

The dimensions for creating slide-in labels from the foil for labeling the vertical softkeys can
be seen in the following diagram.
6OLGHLQODEHOV
&HQWHURIWKHNH\
7HLO

7HLO
7HLO
7HLO
7HLO7HLO
5







Figure 7-2 Dimensions for slide-in labels
Note
The symbols for the four softkeys for navigation in the menus shown in the figure are not
contained in the blank film. You can obtain the symbols from the "Symbols_OP08T_13.doc"
document that accompanies the DOConCD. Alternatively, you can also use the
"Template_OP010.pdf" file as print template also provided on the DOConCD - under Separate
supply > Slide-in labels > OP010. To print the film, proceed as described in the "Operator panel
front: OP08T” manual under “Accessories” → “Printing the slide-in labels”.
7.2 Replacement
NOTICE
Risk of damage to sensitive components due to static electricity
Spare parts must always be replaced by properly trained personnel!
Spare parts
7.2 Replacement
Operator panel front: OP 010
106 Manual, 07/2018, A5E36371538B