Siemens SINUMERIK 840D sl OP 010 - Installation and Mounting Procedures; Preparation for Panel Mounting

Installation
5
5.1 Preparation for mounting
Table 5-1 Dimensions of the mounting opening
Width (mm) Height (mm)
450 290
Thanks to the tension jacks on the OP 010, drill-holes or screw holes are not needed.
This retaining method also enables the IP65 degree of protection (but only in conjunction with
a circumferential seal and when the protective USB cap is fitted).
3UHVVXUHSRLQWV
IRUWHQVLRQMDFNV
6HDOLQJDUHD
7HQVLRQMDFNVZLWKVHWVFUHZV
0RXQWLQJSDQHO
,QWKHVHDOLQJDUHD
5]

s
s



Figure 5-1 Dimension sheet for installing the OP 010 operator panel front
Table 5-2 Dimensions to be observed when installing
Mounting depth T3 + clear‐
ance (mm)
Opening depth T5
(mm)
Protrusion P
(mm)
PCU 50.5 104 + 10 380 36
TCU x0.2 53 + 10 353 -15
Operator panel front: OP 010
Manual, 07/2018, A5E36371538B 97