1.4.2.4 How to calibrate a touch panel
NOTICE
Service life of the touch screen
Do not touch the operating elements of the display with pointed or hard objects. This may
considerably reduce their service lives.
With each HT 8-device, a Touchpen (order no. 6FC5348-0AA08-4AA0) is delivered. This
should be used for calibration purposes and during operation.
Calibrate touch screen
The calibration is automatically started after switching on HT 8.
1. Follow the instructions on the screen:
2. Press the three calibration items one after the other.
This completes the calibration.
3. Press the corresponding horizontal softkey on the touch screen to close the command shell
and to re-establish the connection to the desired PCU.
General information and networking
1.4 Networking
Operator panel front: OP 010
58 Manual, 07/2018, A5E36371538B
To Next Page
Loading...
