Siemens SINUMERIK 840D sl TCU 30.3 - Page 57

• The computer to be monitored must be con󹪝gured in the con󹪝g.ini con󹪝guration 󹪝le of the
TCU according to the general con󹪝guration for a TCU in a separate host section as a
switchover target for this TCU.
Where necessary, a password has to be speci󹪝ed in the con󹪝guration, if the VNC server
requires one on the target system (see below).
• To ensure that the TCU recognizes the new switchover target, the TCU requires a restart and
reboot.
• The screen resolution of the observed computer must be adjusted to the characteristics of
the TCU. Otherwise the TCU scales the image it receives to match the display area available
to the TCU, which impairs the quality of the display on the TCU.
Con󹪝guration
1&8
7&8
6\VWHPQHWZRUN
1HWZRUN
3*3&
;
;
Figure6-1 Con󹪝guration example
Con󹪝guration
The con󹪝g.ini 󹪝le is located in the following directory:
NCU:
/user/common/tcu/<TCU name>/common/tcu
PCU/IPC (Windows7 and Windows 10):
C:\ProgramData\Siemens\MotionControl\user\common\tcu\<TCU
name>\common\tcu
The con󹪝g.ini 󹪝le must be stored on the boot server (active DHCP).
Networking
6.3Network con󹪝guration
TCU 30.3
Equipment Manual, 03/2023, A5E40874197B AD 57