Frames
6.6 Preset offset (PRESETON)
Job planning
6-20 Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
6.6 6.6 Preset offset (PRESETON)
Function
In special applications, it can be necessary to assign a new programmed actual value to one
or more axes at the current position (stationary).
Caution
The reference point becomes invalid with the function PRESETON. You should therefore
only use this function for axes which do not require a reference point. If the original system is
to be restored, the reference point must be approached with G74 – see the "File and
Program Management" section.
.LQHPDWLFWUDQVIRUPDWLRQ
3UHVHWRIIVHW
0&6
;
0&6
<
0&6
<
Programming
PRESETON(axis, value, ...)
Parameters
PRESETON Preset actual value memory
Axis Machine axis parameter
Value New actual value to apply to the specified axis
Note
Preset mode with synchronized actions should only be implemented with the keyword
"WHEN" or "EVERY".
To Next Page
Loading...
Need help?
General
