Siemens SINUMERIK 840D

Path traversing behavior
9.3 Curve tables (CTAB)
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
9-19
Programming
Modal language commands with curve tables
CTABDEL(n, m, memType)
or
CTABNOMEM (memType)
or
CTABFNO(memType)
or
CTABID(n, memType)
or
CTABLOCK(n, m, memType) or CTABUNLOCK(n, m, memType)
or
CTABDEL(n) or CTABDEL(n, m)
or
CTABLOCK(n) or CTABLOCK(n, m) or CTABLOCK() or
CTABLOCK(, , memType)
or
CTABUNLOCK(n) or CTABUNLOCK(n, m) or CTABUNLOCK() or
CTABUNLOCK(, , memType)
or
CTABID(n) or CTABID(n, memType) or CTABID(p, memType)
or
CTABISLOCK(n)
or
CTABEXISTS(n)
or
CTABMEMTYP(n)
or
CTABPERIOD(n)
or
CTABSEGID(n, segType)
or
CTABSEG(memType, segType) or CTABFSEG(memType, segType) or
CTABMSEG(memType, segType)
or
CTABPOLID(n) or CTABMPOL(memType)