Additional functions
13.13 Master/slave grouping (MASLDEF, MASLDEL, MASLOF, MASLOF, MASLOFS)
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
13-55
After rotation by one slot:
Direction of
rotation of the
container
Mechanical
infeed
References:
/FB2/ Function Manual, Extension Functions; Several Operator Panel Fronts and NCUs (B3),
Section "Axis container "
Description
General
MASLOF This statement is executed directly for spindles in speed control mode.
The slave spindles rotating at this time retain their speeds until next
speed programming.
Dynamic configuration extension
MASLDEF Definition of a master/slave grouping from the parts program: Previously,
the definition was defined exclusively via machine data.
MASLDEL The statement revokes the assignment of the slave axes to the master
axis and disconnects at the same time, analog to MASLOF, the coupling.
The master/slave definitions specified in the machine data are retained.
MASLOFS MASLOFS can be used to decelerate slave spindles automatically when
disconnecting the coupling.
For axes and spindles in positioning mode, the coupling can only be
closed and disconnected while stopped.
To Next Page
Loading...
Need help?
General
