Flexible NC programming
1.14 Interrupt routine (SETINT, DISABLE, ENABLE, CLRINT)
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
1-53
The reference plane is derived from the longitudinal tool axis (infeed direction) and a vector
positioned perpendicular to this axis and perpendicular to the tangent at the point of
application of the tool.
,QWHUYHQWLRQ
SRLQW
,QWHUYHQWLRQ
SRLQW
7DQJHQW
7DQJHQW
7DQJHQW
7DQJHQW
Code number with traversing directions summarized
The code numbers and the traversing directions in relation to the reference plane are shown
in the diagram on the right.
,QIHHGD[LV
9LHZLQWKH
WUDYHUVLQJGLUHFWLRQ
7UDYHUVLQJGLUHFWLRQ
3ODQYLHZ
r
r
*
*
ALF=0 deactivates the liftfast function.
To Next Page
Loading...
