Siemens SIPROTEC 5 Compact Hardware Description

[dwklest1-030211-01.tif, 1, --_--]
Figure 5-10 Example of a Current Terminal with Connection of Cross Connectors and Single Cables
[dwklest2-030211-01.tif, 1, --_--]
Figure 5-11 Example of a Current Terminal with Connection of 2 Single Cables
You can connect solid conductors as well as stranded-wire conductors with ring-type lug or bootlace ferrule.
For each connection, you can install up to 2 single cables of the same type and the same cross-section.
Bridges can be used as an alternative for horizontally arranged clamping points. If bridges are used, only ring-
type lugs may be used.
The following cable cross-sections can be used for the connection of single cables:
Cable cross-section
AWG (American Wire Gauge) 14-10
(2.0 mm
2
to 4.0 mm
2
(0.0031 in
2
to 0.0062 in
2
))
Ferrule with plastic shroud L = 10 mm (0.39 in) or L = 12 mm (0.47 in)
Stripped length 15 mm (0.59 in)
For use without ferrule Use solid copper cables only.
i
i
NOTE
Always guide the solid conductor or stranded-wire conductor with bootlace from the left- or right-hand side
ferrule into the terminal. Making contact from the center is not permitted.
Mechanical Requirements
The fasteners and their associated components are designed for the following mechanical requirements:
Working on the Device
5.3 Installing Current and Voltage Terminals
SIPROTEC 5 Compact, Hardware Description, Manual 49
C53000-G5300-C002-3, Edition 12.2021

Siemens SIPROTEC 5 Compact Specifications

General

Brand	Siemens
Model	SIPROTEC 5 Compact
Category	Industrial Equipment
Language	English