Siemens SIREMOBIL Compact L - Installing the Line Filter

SIREMOBIL Compact L n.a. SPR2-130.841.02 Page 6 of 10 Siemens AG
System Manual Rev. 01 07.05 CS PS 24 Medical Solutions
3 - 6 Installing the lifting column
Installing the line filter 3
• Screw in and tighten the 4 studs (1/Fig. 11) with the short thread adapters in the bores of
the lifting column.
• Fit the base plate and tighten with 4 M4 nuts and contact washers.
• Run the cable back through behind the lifting column to the right.
• Fasten all protective conductors (2/Fig. 12) back on the base plate of the line filter,
and insert contact washers between cable lug and base plate.
• Fasten the line filter with two screws to the base plate.
• Fasten the BNC plug on the base pate.
• Plug in the BNC cable.
Fig. 11
Fig. 12 Fig. 13
1
2