Siemens SIREMOBIL Compact L - Adjustments; Programs; Generator, kV offset adjustment

Installing the lifting column 3 - 7
Siemens AG n.a. SPR2-130.841.02 Page 7 of 10 SIREMOBIL Compact L
Medical Solutions Rev. 01 07.05 CS PS 24 System Manual
Installing the switch-mode power supply M 14 3
• Install the base plate.
• Install the switched-mode power supply with the plug-in connections downwards.
• Plug in the connections.
• Screw the protective conductor onto the base plate of the line filter and place the contact
washer under the cable lug.
Installing the stabilization bracket 3
• Fasten the stabilization bracket of the monitor cable plug again.
• Fasten the protective conductor on the unit floor and on the chassis, and place the
contact washers under the cable lugs.
Installing the boards D1 and D2 3
• Fasten the heat sink on the lifting column operating side (Fig. 13).
• Fasten 6 spacer screws on the heat sink (Fig. 13).
• Apply heat conduction paste on the contact surface for the the heat sink.
• Fit the board D2 on the spacer screws and fasten it to the heat sink (Fig. 13).
• Plug in the connectors on D2 board.
• Fasten the D2 board with the spacers (Fig. 13).
• Plug the intermediate plate back on.
• Fit the spacer tubes on the 6 screws.