EasyManua.ls Logo

Siemens SIRIUS 3RW44 - Page 136

Siemens SIRIUS 3RW44
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
General Technical Data
SIRIUS 3RW44 manual
9-12 GWA 4NEB 535 2195-02 DS 02
Type 3RW44 ..
Factory presetting
Control times and parameters
Control times
Closing delay (with connected control voltage) ms <50
Closing delay (automatic mode) ms
<4000
Recovery time (closing command in active ramp-down) ms
<100
Mains failure bridging time
Control supply voltage ms 100
Mains failure response time
Load current circuit ms 100
Reclosing lockout after overload trip
Motor protection trip min. 1...30 1
Device protection trip s
30
Setting options for starting
Voltage ramp for starting voltage % 20 ... 100 30
Torque control for starting torque %
20 ... 100 50
Torque control for limit torque %
20 ... 200 150
Starting time s
0...360 20
Maximum starting time s
1 ... 1000 Deactivated
Current limit value %
125 ... 550 450
Breakaway voltage %
40 ... 100 80
Breakaway time s
0...2 Deactivated
Motor heat output %
0...100 0
Creep mode Left/Right running
Speed factor as function of rated speed (n = n
rated
/factor) 3...21 7
Creep torque (reference variable depends on the motor used but is
always smaller than the rated torque of the motor)
%
20 ... 100 50
Setting options for ramp-down
Torque control for stopping torque % 10 ... 100 10
Ramp-down time s
0...360 10
Dynamic braking torque %
20 ... 100 50
DC braking torque %
20 ... 100 50
Operating indications
Test voltage
Test mains phases
Ready to start
Start active
Motor running
Ramp-down active
Warnings/error signals
Mains voltage missing
Leading-edge phase error
Phase failure
•L1
•L2
•L3
Missing load phase
•T1
•T2
•T3
Failure
Contact element 1 (thyristor)
Contact element 2 (thyristor)
Contact element 3 (thyristor)
Flash memory faulty
Supply voltage
Below 75 %
Below 85 %
Over 110 %
Current unbalance exceeded
Thermal motor model overload
Prewarning limit exceeded
Motor heating
Time-related trip reserve
Bypass elements defective
Mains voltage too high
Device not named
Wrong naming version
Current range exceeded
Motor blocking – shutdown
Current limit exceeded
Power section
Overheated
Overtemperature
Emergency active

Table of Contents

Other manuals for Siemens SIRIUS 3RW44

Related product manuals