Siemens SIRIUS 3UG4 - Operation

12.4 Operation
Parameters
Parameterization of the devices is possible locally using the display and the three keys.
Parameter information
The table below shows the settable parameter information of the 3UG4651 speed monitoring
relays:
Table 12-2 Parmeter information, 3UG4651 speed monitoring relays with digital setting
Menu
level
Parameters Setting range Increment Factory setting
Minimum value Maximum value
"RUN" Threshold for undershoot
(rpm▼)
0.10 or OFF 2200 or OFF 0,1 800
"RUN" Threshold for overshoot (rpm▲) 0.10 or OFF 2200 or OFF 0,1 1400
"SET" Scaling factor (Scale) 1 10 1 1
"SET" Hysteresis (Hyst) 0.1 or OFF 99,9 0,1 Disabled (OFF)
"SET" ON-delay time (onDel) 0 s 900.0 s 0.1 s Deactivated (0 s)
"SET" Tripping delay time (Del) 0.1 s 99.9 s 0.1 s 0.1 s
"SET" Reset response (Mem) no = Autoreset yes = Hand‑RESET -- no = Autoreset
"SET" Relay switching behavior
(closed-circuit principle NC /
open-circuit principle NO)
NC or NO -- NC
Note
The monitoring mode "Overshoot" or "Undershoot" is de󹪝ned with the setting OFF at the
threshold for undershoot or overshoot.
The parameters are described in Chapter "Parameters (Page 281)."
Menu-based operation is described in Chapter "Menu-based operation (Page 44)."
3UG4651 speed monitoring relay
12.4 Operation
SIRIUS 3UG4 / 3RR2 monitoring relay
234 Equipment Manual, 07/2021, NEB927043002000/RS-AD/005