Description
3.4 BUS Communication
SITRANS F M TRANSMAG 2
Operating Instructions, 11/2009, A5E00102775-07
11
– Simulation of output signal via analog output, digital output 1 and digital output 2
– Option: digital output 2 as digital input for resetting counter values or for interruption in
measurement (PZR)
3.4 BUS Communication
SITRANS F M Transmag 2 is available with HART or PROFIBUS communication.
● The HART protocol is superimposed on the analog output (current output). This
communication capability permits parameterization of the device using the HART
communicator or a PC/laptop and SIMATIC PDM software in addition to local operation.
● In the PROFIBUS PA version, the analog output and the digital output 2 are replaced by
the digital PROFIBUS PA output. Parameterization of the device is then possible using
PROFIBUS communication and SIMATIC PDM in addition to local operation.
To Next Page
Loading...
