Siemens SITRANS F M TRANSMAG 2 - Parameters

SITRANS F M TRANSMAG 2
Operating Instructions, 11/2009, A5E00102775-07
79
Parameters
A
The device functions and parameters are listed below with the factory setting and setting
option. The menu code only appears in the local display.
Display
Table A- 1 Function group display parameters
Menu code Device function,
Parameters
Description Factory setting Setting options
1.1 Display Param. Setting parameter for the local display
Language Language for user guidance Deutsch
• Englisch
• Deutsch
• Français
• Italiano
• Español
• Nederlands
1.1.2 Line 1 Definition of measured values to be
displayed for line 1 in multi-display
Flow
• Flow
• Totalizer net
• Flow velocity
• Analog Val. 1, 2,
• Frequency
1.1.3 Line 2 Definition of measured values to be
displayed for line 2 in multi-display
Totalizer net
• Flow
• Totalizer net
• Flow velocity
• Analog Val. 1, 2,
Frequency
1.1.4 Display flow Selection for type of presentation of the
flow rate (% and bargraph only apply to
line 2)
When the "Flow" parameter has been
selected for lines 1 and 2, "Bargraph in %"
is always shown in line 2.
Engineering Unit
• Engineering Unit
• %
• Bargraph in %
1.1.5 LCD lighting Lighting of the display
On: permanently switched on
Off: automatic switch on by pressing key,
switch off after 10 min
.Off
• On
• Off
1.2 Multi-Display Simultaneous display of two measuring
variables
(actual
measured value
line 1)
(actual
measured value
line 2)
• Menu 1.1.2
• Menu 1.1.3