Parameters
SITRANS F M TRANSMAG 2
Operating Instructions, 11/2009, A5E00102775-07
81
2.5.1 Flow Simulation of a flow value; affects all
outputs, totalizers, limit values and
display.
"F" flashes in the top right of the display
during simulation and "Simulation" is
displayed under device status.
Value Simulation value in % of full scale value 0 % -110% to +110%
Time Duration of simulation
After expiration of this time or with input of
"End" the normal measuring mode is
resumed
End
• End
• 10 min
• 30 min
• 60 min
2.5.2 Dig. Out.1 Simulation of output signal at the digital
output 1
End
• End
• 0.1 Hz
• 1 Hz
• 10 Hz
• 100 Hz
• 1 kHz,
• 10 kHz
• Alarm on
• Alarm off
2.5.3 Dig. Out.2
1
Simulation of the output signal at the
digital output 2
End
• Alarm on
• Alarm off
2.5.4 Analog Out.
1, 2
Simulation of the output signal at the
analog output
4 mA
• 0 mA
• 4mA
• 10mA
• 12mA
• 20mA
• Failure signal
1)
Parameters apply only to devices with 20 mA/Hart communication and digital output 2 (7ME5034-0xxxx)
2)
Parameters apply only to devices with 20 mA/Hart communication and digital input (7ME5034-2xxxx)
To Next Page
Loading...
