4. Remove the screw holding the transmitter cassette. Pull out the transmitter cassette.
5. Changing termination at the transmitter cassette, by changing the position of the dip
switches as below.
All off: no termination
All on: termination activated
6. Reinstall the transmitter cassette.
Reinstall the display and display cable, incl. the O-ring.
Mount the O-ring by pulling it over the display lid.
Communication
2.5 Changing Profibus termination at the transmitter cassette
FCT030 Profibus (From firmware 4.0)
Function Manual, 06/2018, A5E39931906-AB 11
To Next Page
Loading...
