6. Connect wires to terminals using wiring tool, wall mount transmitter.
PROFIBUS DP/PA
④ In + (B)
⑤ In - (A)
⑥ Out + (B)
⑦ Out - (A)
7. Tighten cable gland.
2.7 Installation check
● Make sure the installation guidelines provided by the "Wiring & Installation Application
Guide" on Profibus Installation guide (http://www.profibus.com/download/installation-
guide/) are followed.
● Make sure the wiring requirements for the device are met.
● Make sure all connectors are properly tightened.
Communication
2.7 Installation check
FCT030 Profibus (From firmware 4.0)
Function Manual, 06/2018, A5E39931906-AB 13
To Next Page
Loading...
