2.5 Changing Profibus termination at the transmitter cassette
To change the termination of the Profibus, it is required to remove the transmitter module out
of the transmitter. This can be done following below instructions.
1. Isolate the device from power.
2. Using tool no. 9, unscrew the locking screw of the display and remove the display lid using
tool no. 3 as a wrench bar if necessary.
3. Carefully remove display and cable plug.
Note
Use a screwdriver, tool no. 11, to release the display as shown in photo below.
The display is held in place with three clips.
Communication
2.5 Changing Profibus termination at the transmitter cassette
FCT030 Profibus (From firmware 4.0)
10 Function Manual, 06/2018, A5E39931906-AB
To Next Page
Loading...
