Note
Empty pipe detection
For applications with empty pipe detection, the sensor can be tilted 45°, as shown above.
4.3 Installation in partially filled pipes
Installation in partially filled pipes
For partially filled pipes or pipes with downward flow and free outlet the flowmeter should be
located in a U-tube.
Installation in large pipes
The flowmeter
can be installed between two reducers (for example DIN 28545). At α ≤ 8° the
following pressure drop curves apply. The curves are applicable to water.
Installing/Mounting
4.3 Installation in partially filled pipes
21
www.eltra-trade.com
info@eltra-trade.com
+421 552 601 099
To Next Page
Loading...
