Siemens SITRANS P DS III - Page 25

SITRANS P DS III/P410 (7MF4.33.. 7MF4.34.. 7MF4.35..)
A5E03434626-04, 05/2015
23
3. Connect the wires to the connecting terminals ④ "+" and "-".
Ensure the correct polarity! If necessary, ground the device using the "-" connection by connecting the "-" connection to
the ground terminal ⑨.
4. If necessary, connect the shield to the screw of the ground terminal
⑨. This is electrically connected with the external
protective conductor connection.
HART
PROFIBUS PA / Foundation™ Fieldbus FF
①
Feed separator with integrated load
⑥
Safety catch
②
Auxiliary power
⑦
Protective conductor connection/
equipotential bonding terminal
③
Cable entry for auxiliary power/analog output
⑧
Process connection
④
Connecting terminals
⑨
Ground terminal
⑤
Test connector for direct current measuring device or
connection for external display (not available with
PROFIBUS PA and Foundation™ Fieldbus FF)
⑩
PROFIBUS PA / Foundation™ Fieldbus FF
Electrical connection, power supply