Siemens SITRANS P - Document History; Product Compatibility

With the appropriate con󹪝guration and the necessary add-on parts (e.g. limiters and remote
seals), you can also use the pressure transmitter for the following measuring tasks:
• Level
• Volume 󹪞ow
• Mass 󹪞ow
• Volume
• Customized characteristic curve
The output signal for all measuring tasks is a direct current of 4 to 20 mA or a process-based,
digital signal (e.g. with PROFIBUS PA).
You can install the "intrinsically-safe" or "󹪞ameproof enclosure" version of the pressure
transmitter in hazardous areas. The devices have a test certi󹪝cation and comply with the
corresponding directives.
Pressure transmitters with remote seals of various shapes can be provided for special
applications. For example, measuring high-viscosity substances is a special application.
Operate the device in accordance with the speci󹪝cations in section Technical data (Page 61).
2.4 Document history
Edition Note
01/2021
• Technical data updated (e.g. introduction of the 160 bar measuring cell and the
internal overvoltage protection up to 6 kV)
• New variant of the device with PROFIBUS PA.
09/2018
• Section Sealing plug / thread adapter (Page 89) added.
• Technical data updated
06/2018 First edition
2.5 Product compatibility
The following table describes the compatibility between the edition of this manual, the device
revision, the engineering system and the associated EDD.
Edition Comments Device revision Compatible version of device integration package
01/2021 Manual revised HART 7
FW: 1.01.00 or higher
HW: 1.00.00 or higher
SIMATIC PDM V9.0 or higher EDD: 1.01.00 or higher
AMS Device Manager V13 or
higher
DTM Pactware V4.2 or higher
FC475 V3.9 or higher
PROFIBUS PA
FW: 1.00.05 or higher
HW: 1.00.00 or higher
SIMATIC PDM V9.0 or higher EDD: 1.00.00 or higher
DTM Pactware V4.2 or higher
Introduction
2.5 Product compatibility
SITRANS P320/P420
10 Compact Operating Instructions, 01/2021, A5E38874562-AC