SIWAREX WP321
Manual, 07/2014, A5E33715669A-02
11
General safety instructions
Non-compliance with warning notes or non-qualified handling of the system
Failure to observe the warning notes or handling of the device/system by non-qualified
personnel can result in serious injury or damage to property. This means only qualified
personnel are permitted to handle this device/system.
Permission for installation in machines
Start-up/commissioning is absolutely prohibited until it has been ensured that the machine
in which the component described here is to be installed fulfills the
regulations/specifications of Machinery Directive 89/392/EEC.
The specifications of the manual for the SIMATIC ET 200SP system apply for configuration,
installation and commissioning in the SIMATIC environment. This chapter includes add
information on hardware configuration, installation and preparation for operation of the
SIWAREX WP321.
The safety notes must be observed.
The device was developed, manufactured, tested and documented in compliance with the
relevant safety standards. The device does usually not pose any risks of material damage or
personal injury.
To Next Page
Loading...
