Mounting
5.3 Mounting on the SIMATIC ET 200SP
SIWAREX WP321
Manual, 07/2014, A5E33715669A-02
23
Mounting on the SIMATIC ET 200SP
The electronic weighing system described here is a module of the SIMATIC ET 200SP
series and can be directly connected to the automation system's bus system. The 15 mm
wide module has very low installation and cabling requirements.
The module is snapped onto the ET 200SP base unit (BU). You must use base units of type
A0 (→ Accessories (Page 115)).
The load cells, power supply and serial interfaces are connected via the terminal box.
Figure 5-1 Installation of the I/O or SIWAREX modules
To Next Page
Loading...
