List of Figures
Figure 1: Links for sensitivity (two per loop) 9
Figure 2 : Reading the SLD4 Configuration 12
Figure 3 : Setting Configuration 13
Figure 4 : Setting Loop Mode 14
Figure 5 : Evaluating Loop Settings Using data Capture 15
Figure 6 : Reading the estimated inductance values 19
Figure 7 : Vehicle Records (German language settings) 20
Figure 8 : Vehicle Profile 20
Figure 9 : Loop Sensitivity Settings (%DL/L and [Hz] are site dependent) 21
Figure 10 : New Vehicle Profile with New Threshold 21
Figure 11 : Disconnecting the Serial COM Interface 22
Figure 12 : Example Loop Dimensions for Bicycle Detection 23
Figure 13 : General Vehicle Loop Configuration 25
Figure 14 : Loop Frequency 26
Figure 15 : Loop Status 26
Figure 16 : Location of Classification Settings 27
Figure 17 : Classification Mode Selection (General Tab) 27
Figure 18 : Classification Bin Configuration 28
Figure 19 : Example 1 Classification bin configuration 29
Figure 20 : Digital output configuration Example 1 Mapping 30
Figure 21 : Example 2 Classification bin configuration 31
Figure 22 : Digital output configuration for Example 2 32
Figure 23 : Presence Time (s) Settings 33
Figure 24 : SLD4 Configuration Tool – Creating a New Configuration 34
To Next Page
Loading...
