9 – 94
Configurable digital output modules
The configurable output module is pre-programmed with the most frequently-used events assigned to the outputs. The configuration can be
changed using:
-the with the TD400 through the test connector of the trip unit
- through a COM module using the PC software "powerconfig" (page 29-2).
Indicators
(page 9-86)
Testing
(page 9-86)
Default Event Settings
1: Parameter Set B Active
2: Load Shed Alarm Active
3: Circuit Breaker Open
4: Circuit Breaker Tripped
5: Parameter Set B Active
6: Circuit Breaker Closed
To Next Page
Loading...
