Troubleshooting
Malfunction
"E:30 / -80"
Cause
and troubleshooting
Detergent dosage is too high.
▶ Immediate
measure: mix a tablespoon of fabric
softener with 0.5 l of water and pour this mixture into
compartment II (not for outdoor, sportswear and down
textiles).
▶ Reduce the amount of detergent during the next
wash with the same load.
"E:36 / -25 / -26"
"E:60 / -2B"
Drain pump is clogged.
▶
→
"Clean the drain pump", page 35
.
The imbalance detection system has stopped spinning
due to uneven distribution of the laundry.
▶ Redistribute
the laundry in the drum.
Remark:
If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes better during spinning.
"E:30 /
-10" and/or Water pressure is low.
No solution possible.
Sieve
in the water supply is clogged.
▶ Clean
the strainer in the water supply.
Water tap is closed.
▶ Open
the water tap.
Water supply hose
is kinked or trapped.
▶ Make
sure the water supply hose is not kinked or
pinched.
Water level measuring system defective.
Remark:With the error message, the device starts a
pump-down procedure.
1.First wait approx. 5 minutes until the pumping procedure is
completed.
2.
To reset the error message, switch off the device.
3.
Switch the device back on.
4.
If the error message appears again, contact
customer service.
→
"Service", page 50
40
To Next Page
Loading...
