Troubleshooting
Malfunction
"E:35 / -10"
Cause
and troubleshooting
Water
in the bottom container.
▶ Close the
tap.
▶ Please contact customer service.
→
"Service", page 50
Device is leaking.
▶ Close the
tap.
▶ Please contact customer service.
→
"Service", page 50
flashes.
Voltage
control system recognizes an unacceptable
voltage undershoot.
▶ No
solution possible.
Remark:
Once the supply voltage has stabilized, the
program will continue normally.
Voltage
undershooting can cause a program extension.
No solution possible.
burns. Voltage
undershooting can cause a program extension.
No solution possible.
burns. Temperature is
too high.
▶ Wait until the temperature has dropped.
▶
→
"Program cancel", page 31
Water level is too high.
▶ Select
a suitable program for draining.
→
"Programs", page 24
flashes. Door is not closed.
▶ Close
the door.
Laundry is wedged between the door.
▶ Remove trapped laundry.
Drum
cleaning required.
▶
→
"Clean drum", page 34
"E:30/-20" Detergent dosage is too high.
▶ Reduce
the amount of detergent during the next
wash with the same load.
Extra water filled.
▶ Do
not fill additional water into the device during
operation.
Solenoid valve defective.
41
To Next Page
Loading...
