Troubleshooting
Malfunction Cause
and troubleshooting
Centrifuge result is
not satisfied-
heid. The laundry is
too wet / too damp.
Low spin speed
is set.
▶ Set a higher spin speed
for the next wash.
▶ Start the programCentrifuge .
Drain pipe or water drain hose is clogged.
▶ Clean
the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
trapped.
▶ Make
sure that the drain pipe and water drain
hose are not kinked or trapped.
The imbalance detection system has stopped spinning
due to uneven distribution of the laundry.
▶ Redistribute
the laundry in the drum.
Remark:
If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes better during spinning.
▶ Start the programCentrifuge .
Imbalance control system compensates for
imbalance by reduced spin speed.
▶ Redistribute
the laundry in the drum.
Remark:
If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes better during spinning.
▶ Start the programCentrifuge .
Detergent residue left
the damp laundry.
Detergents can contain water-insoluble substances
that deposit on the laundry.
▶ Start
the programTo rinse .
Detergent residue
the dry laundry.
Detergents can contain water-insoluble substances
that deposit on the laundry.
▶ Brush the laundry after washing and drying.
At the
water supply
feeding hose is leaking water.
The water supply hose is not correctly/tightly
connected.
1.
Connect the water supply hose correctly.
→
"Connecting the water supply hose", page 15
2.Tighten the coupling properly.
Water is leaking from
the water
drain hose.
Water drain hose is damaged.
▶ Replace
the damaged water drain hose.
47
To Next Page
Loading...
