Troubleshooting
Malfunction Cause
and troubleshooting
Spin program
running doesn't start.
The
imbalance detection system has stopped spinning
due to uneven distribution of the laundry.
▶ Redistribute
the laundry in the drum.
Remark:
If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes better during spinning.
▶ Start the programCentrifuge .
Sparkling, hissing
loud.
Water is flushed into the detergent
drawer under
pressure.
▶ No
error - normal operating noise.
Loud noise during
spinning.
The device is not properly leveled.
▶
→
"Adjusting the device", Page 16
Device feet are not fixed.
▶ Secure the device feet.
→
"Adjusting the device", Page 16
Transport protections have not been removed.
▶
→
"Remove transport locks", Page 14
.
Clapping, rattling
in the pump.
A foreign object has entered the pump.
▶
→
"Clean the drain pump", page 35
Slurping, rhythmic
suction sound.
Pump is active, the suds are being pumped off.
▶ No
error - normal operating noise.
Wrinkling. Spin speed is too high.
▶ Set a lower
spin speed for the next wash.
The loading quantity is too high.
▶ Reduce
the load during the next wash.
Unsuitable program set for the textile type.
▶ Choose
a suitable program for the type of textile.
Detergent or laundry detergent
softer drips from
the cuff and collects on
the door or in the cuff
fold.
Too much detergent/fabric softener in the detergent
drawer.
▶ When dosing
liquid detergent and fabric softener,
pay attention to the marking in the detergent
drawer and do not dose above it.
46
To Next Page
Loading...
