Troubleshooting
Malfunction Cause
and troubleshooting
In the compartment
there is residual water.
Insert
in compartment is hidden.
▶
→
"Cleaning the detergent drawer", page
34
Vibration and movement
of the appliance
during the spin cycle
run.
The device is not properly leveled.
▶
→
"Adjusting the device", Page 16
Device feet are not fixed.
▶ Secure the device feet.
→
"Adjusting the device", Page 16
Transport protections have not been removed.
▶
→
"Remove transport locks", Page 14
.
Drum
is spinning, there
no water flows into
the device.
Load recognition is active.
▶ No
error, no action necessary.
Remark:
Load recognition can take up to 2 minutes.
Strong foaming
ming.
Detergent dosage is too high.
▶ Immediate
measure: mix a tablespoon of fabric
softener with 0.5 l of water and pour this mixture into
compartment II (not for outdoor, sportswear and down
textiles).
▶ Reduce the amount of detergent during the next
wash with the same load.
High spin speed
rental is not
achieved.
Low spin speed is set.
▶ Set a higher spin speed
for the next wash.
Imbalance control system compensates for
imbalance by reduced spin speed.
▶ Redistribute
the laundry in the drum.
Remark:
If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes better during spinning.
▶ Start the programCentrifuge .
Spin program
running doesn't start.
Drain pipe or water drain hose is clogged.
▶ Clean
the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
trapped.
▶ Make
sure that the drain pipe and water drain
hose are not kinked or trapped.
45
To Next Page
Loading...
