Copyright © Sigicom AB 2020 24
6. Operation
6.1. Startup
Connect the INFRA sensors to the D10/D10 Micro.
To turn the D10/D10 Micro on, press
The display is lit up and a start screen is first displayed in some seconds. It
presents product type, serial number, custom name (can be set by the user)
and firmware version.
Then the unit is ready for use, but it takes a while to set up the sensor
network which is done automatically.
Main screen:
From the Main screen the following options are available:
• Start monitoring, section 6.2.
• Initiate a manual communication to INFRA Net,
see section 6.5.2.
• Open the GUI menu, see section 6.8.
• Power off – if Monitoring is off, D10/D10 Micro will do an
automatic power off after some minutes.
Error codes, if present, will be indicated at bottom right on the main
screen and should be checked up before monitoring is started. See section
6.8.6.
To Next Page
Loading...
Need help?
General
