Operating Manual SIGMA 2-16P page 29 of 75
04/2007
5.2 Initial Start-Up
Before the initial start-up, please ensure that your centrifuge is
properly set up and installed (see
4.2 "Installation", page 24).
5.2.1 Switching the Centrifuge ON
• Press the mains power switch on the right side of the front (see Fig. 5.1, page
25).
The centrifuge display then illuminates.
5.2.2 Opening and Closing the Lid
The lid can be opened if the centrifuge is at a standstill and if the lid key is
illuminated.
• Press the lid key in order to open the lid (see
5.3.7 "Activating/Deactivating
the Automatic Lid Opening Function", page
43).
The centrifuge cannot be started if the lid is opened.
• To close the lid, press on the left and right side of the lid to ensure that both
of the lid locks lock into place.
) Attention!
A flashing lid key indicates that only one lid lock has locked.