Version 06/2007, Rev. 1.15 of 16/09/2011 - sb page 16 of 75
Translation of the original operating manual
2.4 Safety Instructions for Centrifugation
• Ensure that the centrifuge was set up properly (see section 4.2 “Installation”,
page 23).
• Check the centrifuge, rotor, and accessories for external signs of damage
prior to start-up.
• Do not use the centrifuge with rotors and accessories that have not been
approved by the manufacturer. In case of doubt, contact our service team
(See 6.2.7 "Service Contact", page 46).
• Ensure that rotor and buckets are correctly fitted (see 5.2.3 "Installation of
Rotors“, page 29 and Fig. 2.3).
• Please observe the instructions on the installation of accessories (see 5.2.4,
page 31).
• The load of the rotor as defined by the manufacturer and the maximum speed
must not be exceeded (see the engraving on the rotor or bucket).
• The rotor must be loaded symmetrically at equal weights.
To Next Page
Loading...
Need help?
General
